- The dual exhaust consists of the LS/RS front exhaust pipes, LS/RS rear exhaust pipes, dual in/dual out transverse muffler, and LS/RS tailpipes.
- Metal-to-metal connection at the manifolds, no gasket required.
- 1960 models are flanged connected between the front and rear exhaust pipes but then clamped the remainder of the system.
- 1961 models are flanged connected until the tailpipes, which are clamped on. Gaskets are required between rear exhaust pipes and muffler inlets.
-
This listing covers model years 1960 and 1961 Buick LeSabre, Invicta, Electra and Electra 225 with V8 dual exhaust and a transverse muffler. Photo depicts the stock dual exhaust for 1961 Buick Invicta's & LeSabre's with the stock V8. -
Listing covers MY's 1960 and 1961 Chryslers stock with the Ram Induction setup. Photo is correct to the listing.- Ram Induction dual exhaust system consists of LS/RS front exhaust pipes (AKA preheater tubes), LS/RS center exhaust pipes, cross-over (these 5 pipes make up an "H" pipe), LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tailpipes along with the 1&1/8" clamps needed at the preheater tubes.
- The tailpipes are short on the 300; they end in front of the bumper and they are tucked up tightly under the trunk pan. You can’t see the tailpipe tips from the side of the vehicle.
- The tailpipe hangers attach at the radius of the turndown, not on a straight section of pipe. This is a Waldron's exclusive design.
-
This listing covers 1960 and 1961 DeSoto's with the Ram Induction set up. Photo depicted is for a 1960-61 Chrysler and is posted here since these systems are very similar in configuration (but require different parts).
- Ram Induction dual exhaust system consists of LS/RS front exhaust pipes (AKA preheater tubes), LS/RS center exhaust pipes, cross-over (these 5 pipes make up an "H" pipe), LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tailpipes along with the 1&1/8" clamps needed at the preheater tubes.
-
Listing covers MY 1960, and 1961 Desoto's stock with the stock V8 and single exhaust. Photo shown is generic and is posted so that you might see the quality of our craftsmanship and the type of bending.- Single exhaust system consists of a Y pipe (which comes in 3 sections), muffler, and tailpipe. Y pipe may be NORS.
-
Listing covers model years 1960 and 1961 Dodge's with the Ram Induction set up. Photo depicted is for a 1960-61 Chrysler and is posted here since these systems are very similar in configuration (but require different parts).
- Ram Induction dual exhaust system consists of LS/RS front exhaust pipes (AKA preheater tubes), LS/RS center exhaust pipes, cross-over (these 5 pipes make up an "H" pipe), LS/RS rear exhaust pipes,LS/RS mufflers, and LS/RS tailpipes.
-
This listing covers model year 1960 & 1961 Dart, Lancer, and Swinger's stock with the Ram Induction set-up. Photo depicted is for a 1960-61 Chrysler and is posted here since these systems are very similar in configuration (but require different parts).
- Dual exhaust system consists of LS/RS front exhaust pipes, LS/RS Y (AKA center exhaust) pipes, crossover pipe, LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tail pipes.
-
This listing covers MY's 1960 and 1961 Ford Sunliner convertibles.- For 1960 models this dual exhaust consists of LS front exhaust pipe, LS resonator, LS rear exhaust pipe and LS muffler with tailspout while the RS will have a front exhaust pipe, rear exhaust pipe, and muffler with tailspout.
- For 1961 models this dual exhaust consists of LS front exhaust pipe, LS resonator, LS rear exhaust pipe, and LS muffler with tailspout while the RS consists of a long exhaust pipe and RS muffler with tailspout.
-
Photo depicted is for a 1960-61 Chrysler and is posted here since these systems are very similar in configuration (but require different parts).
- Ram Induction dual exhaust system consists of LS/RS front exhaust pipes (AKA preheater tubes), LS/RS center exhaust pipes, cross-over (these 5 pipes make up an "H" pipe), LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tailpipe along with the 1&1/8" clamps needed at the preheater tubes.
-
This listing covers model 1960, 1961, and 1962 Dart, Phoenix, Pioneer, and Seneca stock with a dual exhaust. 1960 MY covers 361ci and 383ci engines, only. No dual's available for 1960 with a 318ci. Photo shown is generic and is posted so that you might see the quality of our craftsmanship and the type of bending.- Dual exhaust system consists of LS/RS exhaust pipes, LS/RS mufflers, and LS/RS tailpipes.
-
This listing covers model years 1960, 1961, 1962, 1963, and 1964 LeSabre, Invicta, Electra, and Wildcat's with a V8 and stock single exhaust. Photo depicts the system for 1962 Electra and Electra 225 stock with a single exhaust.- Single exhaust system includes Y pipe, center exhaust pipe, rear exhaust pipe, transverse muffler and tailpipe. Y pipe may be NORS. Metal-to-metal connection at the manifolds, no gaskets required.
-
This listing covers model years 1960 & 1961 (without Ram Induction), 1962, 1963, and 1964 300's with dual exhaust and mufflers only (no resonators). If your 1960-61 Chrysler 300 was stock with Ram Induction refer to SKU 5987697. If your 1962-64 Chrysler 300 is stock with the Cross Ram engine, refer to listing 598702. Photo depicts the system for 1963-64 Chrysler 300's.- Dual exhaust system consists of LS/RS front exhaust pipes, LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tailpipes.
- We received many inquiries regarding this system fitting 1963-64 New Yorker's. It will NOT due to the fact that the engine on the New Yorker's sits 1" higher to the manifold.
-
This listing covers model years 1960, 1961, 1962, 1963, and 1964 Dodge's with a V8 and stock with a single exhaust.
- Single exhaust system includes Y pipe, rear exhaust pipe, muffler, and tailpipe. Y pipe NORS only.