- Ram Induction dual exhaust system consists of LS/RS front exhaust pipes (AKA preheater tubes), LS/RS center exhaust pipes, cross-over (these 5 pipes make up an "H" pipe), LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tailpipes along with the 1&1/8" clamps needed at the preheater tubes.
- The tailpipes are short on the 300; they end in front of the bumper and they are tucked up tightly under the trunk pan. You can’t see the tailpipe tips from the side of the vehicle.
- The tailpipe hangers attach at the radius of the turndown, not on a straight section of pipe. This is a Waldron's exclusive design.
-
Listing covers MY's 1960 and 1961 Chryslers stock with the Ram Induction setup. Photo is correct to the listing. -
This listing covers model years 1957, 1958 and 1959 Ford retractable hardtop's and convertibles with the stock V8 and dual exhaust. For 1958 Convertibles, this is a resonator eliminator options. If you would like to keep your convertible stock with the resonators, please give us a call. Photo depicts the system for 1957 Skyliner Retractable Hard Tops with the stock V8.- Dual exhaust system consists of LS/RS front exhaust pipes, mufflers, LS/RS front tailpipe, and LS/RS rear tailpipes.
- The front and rear tailpipe sections are different between a Retractable Hard Top and a soft-top Convertible. Please report the body-style appropriately.
-
This listing covers model years 1966, 1967, 1968, 1969, 1970, and 1971 Fairlane & Torino's, 1970-71 Ranchero's with the stock V8 and stock dual exhaust. Excludes 1966-69 Ranchero's & SW's which were stock with a single exhaust only. For 1967 Fairlane & Torino models, this is a resonator eliminator option. For the stock set up, refer 518765. Photo depicts the system for a 1970 Torino SCJ- Dual exhaust consists of the H pipe, LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tailpipes.
-
This listing covers model years 1942, 1943, 1944, 1945, 1946, 1947, 1948, 1949, 1950, 1951, 1952, and 1953 Ford F1, F2, F3, F4, F5 and F6's stock with the V8 and single exhaust. Photo depicts the crossover pipe and Y pipe for 1942-52 F1, F2, & F3's with V8, the muffler and tailpipes vary.- Single exhaust system consists of the crossover pipe, Y pipe, muffler, and tailpipe.
-
This listing covers MY's 1971, 1972, 1973, 1974, 1975, 1976, 1977, 1978, 1979 & 1980 Scouts with the stock V8 304ci or 345ci and single exhaust. Photo depict the system for MY's 1973-77 Scouts with the 108"WB and the stock 304ci or 345ci V8 (tail pipes vary between wheelbases).- For MY's 1971-78 this single exhaust system consists of the LS/RS front exhaust pipes, Y pipe (AKA rear exhaust pipe), muffler, and tailpipe.
- For MY's 1979-80 this single exhaust system consists of the Y pipe, rear exhaust pipe, muffler, front tailpipe and rear tailpipe.
- Y pipe may be NORS
-
This listing cover model years 1963, 1964, and 1965 Riviera's. This listing does NOT cover a 1965 Buick Gran Sport. For that listing refer to listing 568810. Photo is correct to this listing.- Dual exhaust system includes LS/RS exhaust pipes, LS/RS resonators, LS/RS connector pipes (AKA over-axle pipes), single transverse muffler and LS/RS tailpipes.
- System starts out at 2"OD, increases to 2¼"OD on the connector pipes, then reduces down to 1¾"on the tailpipes.
-
This listing covers model years 1955, 1956, 1957, 1958, 1959, 1960, 1961, 1962, 1963, and 1964 Commander, President, Golden Hawk, Silver Hawk, Lark, Hawk, and President Classic with the stock V8 and dual exhaust. Photo depicts the system for a 1962 Hawk hardtop stock with a dual exhaust.- For MY's 1959-64 Lark convertibles and 1963-64 Station Wagon's this dual exhaust consists of LS/RS front exhaust pipes, LS/RS rear exhaust pipes, LS/RS mufflers, LS/RS front tailpipes, and LS/RS rear tailpipes.
- For all other models this dual exhaust consists of LS/RS front exhaust pipes, LS/RS rear exhaust pipes, LS/RS mufflers, and LS/RS tailpipes.
- 1958 Sedans will need to report whether it is a "long wheel base sedan" or "except long wheel base sedan".
- 1963 & 1964 Larks will need to report which type of filter is stock; spin-on filter or cartridge filter.
- 1964 Lark Station Wagons will need to report whether your SW has a sliding roof or not.
-
This listing covers model years 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968, 1969, 1970, 1971,1972, 1973, 1974, and 1975 Scout's stock with either the 4 cyl or 6 cyl engine. This listing EXCLUDES 1970 Scouts with 232ci with manifold exit on the driver side. Photo depicts the system for Scouts after chassis FC60474 which has the muffler after the rear axle.- For Scouts up to chassis FC60474 and/or models with the muffler forward of the rear axle, this single exhaust system consists of an exhaust pipe, muffler, and tailpipe, with the tail pipe exiting out the passenger side.
- For Scouts after chassis FC60474 and/or models with the muffler after the rear axle, this single exhaust consists of a front exhaust pipe, rear exhaust pipe, muffler, and tailpipe, with the tail pipe exiting out the driver side.
- MY's 1961-70 do not require a gasket. MY's 1971-75 will require a gasket.
-
This listing covers MY's 1964-65 Lincoln Continentals with the stock V8.- Dual exhaust system consists of the LS/RS exhaust pipes, LS/RS front mufflers assembly, LS/RS rear muffler assembly. Waldron's Exhaust also supplies you with 1 clamp (used to connect resonator balance tube) and 4 gaskets (used at flanges on inlet/outlet of resonators). System does not include any hangers or bolts. To bolt the system together, use ½-16x1½ Grade 8 bolts (½" diameter / 16 coarse thread / 1½" length).
- Waldron's does not offer any sound level options on these systems. OEM sound level only.
-
This listing covers model years 1966, 1967, 1968, and 1969 Continentals with the stock V8.- Dual exhaust consists of the LS/RS exhaust pipes, LS/RS front mufflers assembly, LS/RS rear muffler assembly. Waldron's Exhaust also supplies you with 1 clamp (used to connect resonator balance tube) and 4 gaskets (used at flanges on inlet/outlet of resonators). System does not include any hangers or bolts. To bolt the system together, use ½-16x1½ Grade 8 bolts (½" diameter / 16 coarse thread / 1½" length).
- Waldron's does not offer any sound level options on these systems. OEM sound level only.
-
This listing covers model years 1975, 1976, 1977, 1978, and 1979 Mark IV, Mark V and Continentals stock with a V8 and single exhaust. Photo depicts the cat-back single exhaust for 1977-79 Continentals stock with the 400ci.- Single cat-back system starts behind the cat(s) and consists of the Y pipe, muffler, over-axle pipe, and resonator with tailpipe.
- MY 1975 Lincoln Mark IV's; you will need to report whether your Mark IV system is a direct fit to the manifolds & has no converters or whether it's stock with a converter on the DS.
- MY 1975 Lincoln Continental's; you will need to report whether your Continental is stock with 1 or 2 converter's.
- MY's 1976-79 all Lincoln's with the single exhaust require 2 converters. Y pipe may be NORS.
-
This listing covers model years 1967, 1968, 1969, 1970, 1971, and 1972 Jeepster Commando and C101 Jeepster's with the stock Dauntless V6 225ci engine. Photo depicts the single exhaust for 1967-72 Jeepster Commando C101 with after-market Saginaw steering and automatic transmission.- Single exhaust consists of the LS/RS exhaust pipes, Y pipe, muffler, and tailpipe.
- You will be asked to report the type of steering on your Jeepster; original Ross steering or after-market Saginaw steering?